Injection Molding
4 Aufrufe
EVOH '2079851475616104452 Flow Marks
Problembeschreibung
EVOH injection molded product surfaces show radial flow marks centered on the gate
Ursachenanalyse
Injection speed too fast causing unstable melt front; mold temperature too low <30°C, the front cools rapidly forming marks
Lösung
1) Use multi-stage injection speed slow-fast-slow to control front stability; 2) Increase mold temperature to 40-50°C to delay front cooling; 3) Stabilize injection pressure to avoid fluctuations; 4) Increase gate area to reduce sudden pressure changes at the gate
Wichtigste Erkenntnis
Flow marks are caused by unstable injection front and rapid cooling; multi-stage injection and high mold temperature are key
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!