Extrusion & Post
9 Aufrufe
Longitudinal Stripes on PU Extruded Film
Problembeschreibung
Continuous stripes 1-3mm wide along the extrusion direction on PU extruded film surface
Ursachenanalyse
Die lip local damage or gap uneven; melt stagnation zone in the die producing unstable flow; pressure fluctuation at the screw front
Lösung
1) Check die lip flatness and gap uniformity ±0.01mm; 2) Clean the die interior to remove stagnation zone carbides; 3) Install a gear pump on the extruder to stabilize melt pressure; 4) Polish die lip to Ra<0.1μm
Wichtigste Erkenntnis
Longitudinal stripes are caused by die defects and pressure fluctuation; die maintenance and pressure stabilization are key
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!