Injection Molding
4 Aufrufe
Severe flash in PVA '2079851475616104452
Problembeschreibung
Flash of 0.05-0.1mm at the parting line of PVA injection molded products, width >2mm, requiring secondary trimming
Ursachenanalyse
Injection pressure too high >80MPa, melt overflowing from the parting line; clamping force insufficient; mold parting line fitting gap >0.02mm
Lösung
1) Reduce injection pressure to 60-70MPa; 2) Increase clamping force or use a larger tonnage '2079851475616104452 machine; 3) Mold fitting gap <0.02mm; 4) Increase melt viscosity to reduce mold penetration tendency
Wichtigste Erkenntnis
Flash is caused by high-pressure injection and mold gap; reducing pressure and improving mold fitting are key
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!