Injection Molding
10 Aufrufe
Sink Marks of Products Due to Insufficient Holding Pressure in PCTG '2079851475616104452
Problembeschreibung
Depressions (sink marks) appear on the product surface, especially at the thick-walled parts.
Ursachenanalyse
The holding pressure or time is insufficient, the shrinkage compensation is inadequate, and the gate solidifies prematurely, cutting off the shrinkage compensation.
Lösung
Increase the holding pressure and extend the holding pressure time; enlarge the gate to delay solidification; optimize the V-P switchover point.
Wichtigste Erkenntnis
PCTG sink marks are a common defect of insufficient holding pressure.
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!