Injection Molding
14 visualizações
Sink Marks of Products Due to Insufficient Holding Pressure in PCTG '2079851475616104452
Fenómeno do problema
Depressions (sink marks) appear on the product surface, especially at the thick-walled parts.
Análise das causas
The holding pressure or time is insufficient, the shrinkage compensation is inadequate, and the gate solidifies prematurely, cutting off the shrinkage compensation.
Solução
Increase the holding pressure and extend the holding pressure time; enlarge the gate to delay solidification; optimize the V-P switchover point.
Conclusão principal
PCTG sink marks are a common defect of insufficient holding pressure.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!