Injection Molding
13 مشاهدة
Sink Marks of Products Due to Insufficient Holding Pressure in PCTG '2079851475616104452
ظاهرة المشكلة
Depressions (sink marks) appear on the product surface, especially at the thick-walled parts.
تحليل الأسباب
The holding pressure or time is insufficient, the shrinkage compensation is inadequate, and the gate solidifies prematurely, cutting off the shrinkage compensation.
الحل
Increase the holding pressure and extend the holding pressure time; enlarge the gate to delay solidification; optimize the V-P switchover point.
الخلاصة الأساسية
PCTG sink marks are a common defect of insufficient holding pressure.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!