Molds & Tooling
8 visualizaciones
PPS Burning and Trapped Gas
Fenómeno del problema
Burnt marks and black spots at the end.
Análisis de la causa
Under high-temperature melt, trapped gas adiabatic compression more easily causes burning; poor venting superimposed with high-speed filling.; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based only on experience
Solución
①Open venting grooves at the end; ②reduce injection speed; ③clean venting grooves; ④optimize gate position.; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
Conclusión clave
PPS high-temperature processing has higher trapped gas risk; venting design must be sufficient.; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a reference for troubleshooting similar problems in the future
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!