Injection Molding
3 visualizaciones
PVC Injection Mold Sticking
Fenómeno del problema
Products stick to mold and get pulled damaged, demolding difficult.
Análisis de la causa
High holding pressure, small draft angle, improper mold temperature; degraded material is more sticky and easier to stick; poor cavity polishing also aggravates; during on-site troubleshooting, verify item by item according to this mechanism, avoid blindly adjusting the machine based solely on experience.
Solución
①Appropriately reduce holding pressure to reduce clamping force and frozen internal stress; ②Increase demolding draft angle to reduce demolding resistance; ③Prevent degradation; ④Polish cavity; ⑤Extend cooling time, demold after products are fully set.
Conclusión clave
PVC mold sticking = 'pressure + draft + degradation': degraded material being stickier is PVC's characteristic; besides reducing pressure and temperature, anti-degradation and polishing are equally important; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence.
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!