Injection Molding
7 visualizaciones
PVC Injection Product Peeling
Fenómeno del problema
Surface layer peeling, obvious at edges.
Análisis de la causa
Mixing contamination, poor plasticization causing poor interlayer bonding, excessive release agent; when PVC plasticization is poor, interlayer fusion is poor; during on-site troubleshooting, verify item by item according to this mechanism, avoid blindly adjusting the machine based solely on experience.
Solución
①Check mixing and contamination, standardize raw material and regrind storage management; ②Improve plasticization quality, eliminate unplasticized particles; ③Control release agent dosage, avoid forming isolation layer on surface; ④Thoroughly purge, remove accumulated material in barrel and hot runner dead corners; ⑤Stabilize melt temperature curve, avoid quality drift caused by temperature fluctuation.
Conclusión clave
PVC peeling = 'contamination and plasticization': interlayer non-fusion caused by poor PVC plasticization is its characteristic; first check contamination then grasp plasticization, release agent dosage must also be controlled.
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!