Injection Molding
6 조회수
PC holding pressure and sink mark stress
문제 현상
【Problem Phenomenon】PC holding pressure improper, sink marks and internal stress problems alternate
원인 분석
PC shrinkage rate 0.5-0.7% is small but holding pressure shrinkage compensation is still needed; holding pressure is 40-60% of injection; excessive holding pressure introduces internal stress, especially PC is sensitive
해결 방법
Holding pressure set at 40-60%; thick-wall rib positions delayed; internal stress parts lower holding pressure with annealing；After adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
핵심 요약
PC holding pressure 40-60%, balancing sink marks and stress at both ends；After confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence；Include this case in the defect archive as a reference for troubleshooting similar problems in the future
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!