Injection Molding
3 조회수
EEA injection warpage deformation
문제 현상
EEA injection molded products warped 2-3mm/100mm after demolding, flatness not up to standard
원인 분석
EEA shrinkage rate large and mold temperature uneven causing shrinkage difference in all directions; improper gate position, flow orientation stress unevenly released; insufficient cooling time
해결 방법
1) Increase mold temperature to 40-60°C to reduce temperature difference; 2) Increase holding pressure to 50-70MPa; 3) Optimize gate position for uniform flow; 4) Extend cooling time; 5) Anneal to release residual stress
핵심 요약
Warpage is caused by shrinkage difference and orientation stress; uniform mold temperature and holding are the key
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!