Extrusion & Post
10 조회수
Longitudinal Streaks on CMC Extruded Film
문제 현상
Continuous streaks 1-3mm wide along the extrusion direction on the surface of CMC extruded film
원인 분석
Local damage or uneven gap at the die lip; melt stagnation zone in the die produces unstable flow; pressure fluctuation at the front end of the screw
해결 방법
1)Check die lip flatness and gap uniformity ±0.01mm; 2)Clean the inside of the die to remove carbonized matter in stagnation zones; 3)Install a gear pump on the extruder to stabilize melt pressure; 4)Polish die lip to Ra<0.1μm
핵심 요약
Longitudinal streaks are caused by die defects and pressure fluctuations; die maintenance and pressure stabilization are the key
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!