Extrusion & Post
13 visualizações
Longitudinal Streaks on CMC Extruded Film
Fenómeno do problema
Continuous streaks 1-3mm wide along the extrusion direction on the surface of CMC extruded film
Análise das causas
Local damage or uneven gap at the die lip; melt stagnation zone in the die produces unstable flow; pressure fluctuation at the front end of the screw
Solução
1)Check die lip flatness and gap uniformity ±0.01mm; 2)Clean the inside of the die to remove carbonized matter in stagnation zones; 3)Install a gear pump on the extruder to stabilize melt pressure; 4)Polish die lip to Ra<0.1μm
Conclusão principal
Longitudinal streaks are caused by die defects and pressure fluctuations; die maintenance and pressure stabilization are the key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!