Extrusion & Post
9 Aufrufe
Longitudinal Streaks on CMC Extruded Film
Problembeschreibung
Continuous streaks 1-3mm wide along the extrusion direction on the surface of CMC extruded film
Ursachenanalyse
Local damage or uneven gap at the die lip; melt stagnation zone in the die produces unstable flow; pressure fluctuation at the front end of the screw
Lösung
1)Check die lip flatness and gap uniformity ±0.01mm; 2)Clean the inside of the die to remove carbonized matter in stagnation zones; 3)Install a gear pump on the extruder to stabilize melt pressure; 4)Polish die lip to Ra<0.1μm
Wichtigste Erkenntnis
Longitudinal streaks are caused by die defects and pressure fluctuations; die maintenance and pressure stabilization are the key
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!