Extrusion & Post
4 조회수
POE extrusion film longitudinal streaks
문제 현상
POE extruded film surface shows continuous streaks along the extrusion direction, width 1-3mm
원인 분석
Local damage to die lip or uneven gap; melt residence zone inside the die produces unstable flow; pressure fluctuation at the screw front end
해결 방법
1) Check die lip flatness and gap uniformity ±0.01mm; 2) Clean the die interior to remove carbonized material in the residence zone; 3) Install a gear pump on the extruder to stabilize melt pressure; 4) Polish die lip to Ra<0.1μm
핵심 요약
Longitudinal streaks are caused by die defects and pressure fluctuation; die maintenance and pressure stabilization are key
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!