Extrusion & Post
3 Aufrufe
POE extrusion film longitudinal streaks
Problembeschreibung
POE extruded film surface shows continuous streaks along the extrusion direction, width 1-3mm
Ursachenanalyse
Local damage to die lip or uneven gap; melt residence zone inside the die produces unstable flow; pressure fluctuation at the screw front end
Lösung
1) Check die lip flatness and gap uniformity ±0.01mm; 2) Clean the die interior to remove carbonized material in the residence zone; 3) Install a gear pump on the extruder to stabilize melt pressure; 4) Polish die lip to Ra<0.1μm
Wichtigste Erkenntnis
Longitudinal streaks are caused by die defects and pressure fluctuation; die maintenance and pressure stabilization are key
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!