Extrusion & Post
4 조회수
Poor melt flowability of MBS-modified PVC
문제 현상
Melt flowability of MBS-modified PVC is poor, extrusion or injection is difficult, and processing efficiency is low
원인 분석
Excessive MBS addition increases melt viscosity
Processing temperature too low, below the 180-220°C lower limit
Insufficient PVC/MBS compatibility, uneven melt
Lubricant system mismatch
Screw design not suitable for PVC/MBS blending
해결 방법
Reasonably control MBS addition amount
Appropriately increase processing temperature to the 180-220°C range
Select MBS models with good compatibility
Optimize the lubricant system
Use a screw design suitable for PVC
핵심 요약
MBS-modified PVC flowability needs ratio and lubrication optimization
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!