Extrusion & Post
3 Aufrufe
Poor melt flowability of MBS-modified PVC
Problembeschreibung
Melt flowability of MBS-modified PVC is poor, extrusion or injection is difficult, and processing efficiency is low
Ursachenanalyse
Excessive MBS addition increases melt viscosity
Processing temperature too low, below the 180-220°C lower limit
Insufficient PVC/MBS compatibility, uneven melt
Lubricant system mismatch
Screw design not suitable for PVC/MBS blending
Lösung
Reasonably control MBS addition amount
Appropriately increase processing temperature to the 180-220°C range
Select MBS models with good compatibility
Optimize the lubricant system
Use a screw design suitable for PVC
Wichtigste Erkenntnis
MBS-modified PVC flowability needs ratio and lubrication optimization
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!