Extrusion & Post
7 visualizações
Poor melt flowability of MBS-modified PVC
Fenómeno do problema
Melt flowability of MBS-modified PVC is poor, extrusion or injection is difficult, and processing efficiency is low
Análise das causas
Excessive MBS addition increases melt viscosity
Processing temperature too low, below the 180-220°C lower limit
Insufficient PVC/MBS compatibility, uneven melt
Lubricant system mismatch
Screw design not suitable for PVC/MBS blending
Solução
Reasonably control MBS addition amount
Appropriately increase processing temperature to the 180-220°C range
Select MBS models with good compatibility
Optimize the lubricant system
Use a screw design suitable for PVC
Conclusão principal
MBS-modified PVC flowability needs ratio and lubrication optimization
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!