Improper stretch rod speed

In the stretch '2079851475616104457 production process, the product exhibits the quality defect of "Improper stretch rod speed". The specific manifestation is that the stretching speed is too fast or too slow, affecting the wall thickness distribution of the product. This defect is relatively common when processing materials such as PET, PP, PC, and its occurrence conditions are usually related to the unreasonable settings of stretching temperature, stretch ratio, blowing pressure, and preform heating uniformity. When the "Improper stretch rod speed" situation is severe, it will cause a series of chain quality defects in the product in terms of appearance, dimensional accuracy, mechanical properties, etc., which not only reduces the functionality and safety of the product in use, but also directly increases the scrap rate and production cost. Therefore, this problem requires systematic diagnosis and optimization from multiple dimensions such as material selection, the status of the stretch '2079851475616104457 machine, heating oven, stretch rod, and blow mold, and stretching temperature, stretch ratio, blowing pressure, and preform heating uniformity.

1. Improper stretching servo parameter settings. This factor causing the problem reflects that certain process conditions or material characteristics in stretch blow '2079851475616104453ing have not met the optimal molding requirements. Such problems are often cumulative and hidden, and should be investigated and verified as key focus items during process debugging and finalization to ensure that hidden dangers are eliminated at the source. 2. Unstable cylinder pressure. Pressure directly determines the filling ability of the melt during the forming process and the effect of conforming to the mold. Insufficient pressure results in incomplete filling and poor replication accuracy; excessive pressure may cause secondary defects such as flash and excessive internal stress. The pressure setting should comprehensively consider factors such as material viscosity, product dimensions, and mold structure. In addition, the insufficient overall coordination of preform heating uniformity and biaxial stretch orientation control is also a factor that cannot be ignored; there are complex interactions and coupling relationships among the process parameters, and the deviation of any one parameter may aggravate the degree of "Improper stretch rod speed" through chain effects. In terms of equipment maintenance, the regular overhaul and precision confirmation of the stretch '2079851475616104457 machine, heating oven, stretch rod, and blow mold are not in place, causing the actual operating parameters of the equipment to deviate from the process requirements, which will also become a potential inducement of the "Improper stretch rod speed" problem.

1. Optimize the stretching speed parameters. Optimization work must be based on an accurate diagnosis of the root cause of the problem, and blind attempts must be avoided. It is recommended to first determine the key influencing factors and their interactions through the process DOE test method or historical production data analysis, and then carry out parameter optimization and structural improvement in a targeted manner to achieve twice the result with half the effort. 2. Stabilize the air supply pressure. Before implementing this measure, its feasibility and expected effect should be fully evaluated, and the details of the plan should be communicated and confirmed with relevant technical personnel; during implementation, closely monitor changes in key quality indicators, promptly record and feedback the adjustment effect, and form reusable process experience. 3. Adopt servo electric cylinder precise control. Before introducing new tools, new materials, or new methods, a full applicability assessment and small-batch verification should be carried out. It is recommended to first conduct offline tests or simulation analysis outside production conditions, and introduce them into the formal production line only after confirming effectiveness and safety. Keep change management records to facilitate subsequent traceability and experience accumulation. In terms of material management, incoming inspection of raw materials upon arrival and in-process inspection of work-in-progress should be strengthened, and the key performance indicators of PET, PP, PC should be strictly controlled to ensure the stability of molding quality from the source.

In summary, the causes of the "Improper stretch rod speed" problem can be attributed to the combined action of multiple factors such as Improper stretching servo parameter settings, Unstable cylinder pressure. Solving this problem requires starting from aspects such as Optimize the stretching speed parameters, Stabilize the air supply pressure and adopting systematic governance measures. In actual production, it is recommended to establish a prevention and rapid response mechanism for this problem, and achieve stable production and continuous improvement through preform heating uniformity and biaxial stretch orientation control.