Blow Molding
6 views
Poor wall thickness control accuracy of K-RESIN blow molded containers
Problem Phenomenon
Wall thickness control accuracy of K-RESIN blow molded containers is poor, locally too thin or too thick
Cause Analysis
Low K-RESIN parison viscosity, fast sag, uneven wall thickness
Difficult parison temperature control
Improper blow-up ratio design
Improper wall thickness controller parameter settings
K-RESIN rubber component causes parison elasticity differences
Solution
Reduce parison temperature to reduce sag
Precisely control parison temperature
Reasonably design the blow-up ratio
Optimize wall thickness controller parameters
Use K-RESIN elastic characteristics to adjust the blowing strategy
Key Takeaway
K-RESIN '2079851475616104457 needs precise control of parison temperature and blow-up ratio
Was this helpful?
0 people found this helpful
Thank you for your feedback!