Injection Molding
3 views
EEA Periodic Surface Ripples
Problem Phenomenon
Periodic ripples on the surface of EEA products, spacing 5-15mm
Cause Analysis
Injection speed fluctuates periodically; hydraulic system unstable; screw speed unstable
Solution
1) Overhaul the injection system to stabilize pressure and speed; 2) Servo motor drive instead of hydraulic drive; 3) PID control to stabilize injection parameters
Key Takeaway
Ripples are caused by unstable injection; equipment overhaul and PID control are key
Was this helpful?
0 people found this helpful
Thank you for your feedback!