Extrusion & Post
8 visualizações
LLDPE Blown Film Poor Plasticization (Unmelted Particles)
Fenómeno do problema
White unplasticized particle points appear on the film surface, especially obvious on stretch film.
Análise das causas
LLDPE has high viscosity and is difficult to plasticize, and ordinary screws with insufficient mixing produce unmelted particles; they appear in batches when output is too high beyond the plasticization capacity.
Solução
① Use a special screw with barrier section + mixing section; ② reduce output or raise barrel temperature; ③ use finer filter screens to intercept; ④ check screw wear.
Conclusão principal
LLDPE has the highest requirements for screw mixing, and ordinary screws are not enough.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!