Injection Molding
2 visualizações
PEI Injection Speed Management
Fenómeno do problema
Improper PEI injection speed settings cause filling defects or shear problems; the speed window is difficult to grasp.
Análise das causas
PEI's high viscosity requires a relatively high injection speed, recommended at 50~80% of the screw's maximum speed; too fast causes shear heat and air entrapment; too slow causes front freezing and short shots; multi-stage injection balance.
Solução
①Injection speed in the range of 50~80% of the screw's maximum speed; ②multi-stage injection curve optimization; ③appropriate speed control in the gate area; ④verify filling status with short shot tests.
Conclusão principal
The 50~80% of PEI injection speed is quantitative guidance; multi-stage curves are a refined means; short shot tests provide intuitive verification.; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!