Molds & Tooling
7 visualizações
PPO Jetting Marks
Fenómeno do problema
[Problem Phenomenon] Snake-shaped jetting marks near the gate of PPO products, poor appearance
Análise das causas
High-viscosity melt jets when passing through a small gate at high speed directly facing an empty cavity; the main cause is that the gate design does not guide the melt to hit the wall as soon as possible; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based only on experience
Solução
Use overlap or fan gates to guide wall-following filling; arrange the gate facing the core; reduce the initial speed through the gate; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
Conclusão principal
PPO jetting is radically cured by gate wall-hitting arrangement, and fan and overlap gates are preferred; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a reference for troubleshooting similar problems in the future
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!