Extrusion & Post
13 visualizações
EMA Extruded Film Has Gel Particles
Fenómeno do problema
0.1-0.5mm transparent gel particles appear on the surface of EMA extruded film
Análise das causas
High-molecular-weight components in EMA are not fully melted during extrusion, forming local high-crystallinity zones; extrusion temperature low or mixing insufficient
Solução
1) Increase extrusion temperature by 5-10°C to ensure full melting; 2) Increase screw mixing section length; 3) Inspect raw material to ensure consistent grade; 4) Replace with a finer 120-mesh screen to intercept unmelted particles
Conclusão principal
Gel particles are caused by insufficient melting; increasing temperature and mixing are key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!