Material Drying
7 visualizações
Bubbles appear inside or on the surface of extruded products
Fenómeno do problema
Bubbles appear inside or on the surface of extruded products, voids visible in pipe or profile cross-sections
Análise das causas
Raw material moisture content exceeds standard, vaporizing at high temperature
Extrusion temperature too high (exceeding the upper limit of 170-230°C), thermal degradation
Insufficient screw venting section, poor venting
Poor die venting
Regrind contains moisture
Solução
Fully dry the raw material under 75-85°C/3-4h conditions
Lower the extrusion temperature to a reasonable value of 170-230°C
Ensure the screw venting section is effective
Add die venting
Fully dry the regrind
Conclusão principal
Extrusion bubbles need to be addressed from drying and venting
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!