Extrusion & Post
7 visualizações
PET extrusion output fluctuation and surging
Fenómeno do problema
PET extruder output fluctuates periodically, accompanied by pressure fluctuation and current swing.
Análise das causas
Feed zone temperature too high, material melts prematurely and wraps the screw (bridging), screw design unsuitable for PET (improper compression ratio), poor feeding.
Solução
Reduce feed zone temperature (water cooling 60-80°C); use PET dedicated screw (compression ratio 2.5-3.0:1); check feeding.
Conclusão principal
PET extrusion surging is often caused by feed zone problems; screw design and temperature control are fundamental.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!