Extrusion & Post
11 görüntüleme
Melt fracture in PVA extrusion
Sorun Belirtisi
When extrusion rate is too high, PVA shows severe melt fracture, extrudate twisted in spiral shape
Neden Analizi
PVA melt elasticity too high, elastic recovery at die exit exceeds critical value; die L/D ratio too short <10, melt not fully relaxed; extrusion temperature too low
Çözüm
1) Reduce extrusion rate to 2-3m/min; 2) Increase die length-to-diameter ratio to 15-20; 3) Increase extrusion temperature to 140-200°C; 4) Add a small amount of low-elasticity resin to reduce system elasticity; 5) Gradually converging die entrance design
Temel Çıkarım
Melt fracture is caused by elastic recovery exceeding the critical value; reducing speed and lengthening the die are the core countermeasures
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!