Extrusion & Post
12 مشاهدة
Melt fracture in PVA extrusion
ظاهرة المشكلة
When extrusion rate is too high, PVA shows severe melt fracture, extrudate twisted in spiral shape
تحليل الأسباب
PVA melt elasticity too high, elastic recovery at die exit exceeds critical value; die L/D ratio too short <10, melt not fully relaxed; extrusion temperature too low
الحل
1) Reduce extrusion rate to 2-3m/min; 2) Increase die length-to-diameter ratio to 15-20; 3) Increase extrusion temperature to 140-200°C; 4) Add a small amount of low-elasticity resin to reduce system elasticity; 5) Gradually converging die entrance design
الخلاصة الأساسية
Melt fracture is caused by elastic recovery exceeding the critical value; reducing speed and lengthening the die are the core countermeasures
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!