Material Drying
5 görüntüleme
Internal Voids of CMC
Sorun Belirtisi
Voids of 1-3mm appear inside CMC products, concentrated in the center of thick walls
Neden Analizi
Holding is insufficient and the center of the thick wall is not compacted; entrapped gas cannot be discharged; raw material moisture vaporizes
Çözüm
1)Increase holding pressure 60-80MPa for full compaction; 2)Increase mold venting; 3)Fully dry raw material
Temel Çıkarım
Internal voids are caused by insufficient holding and gas entrapment; high-pressure holding and venting are the key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!