Material Drying
3 Aufrufe
Internal Voids of CMC
Problembeschreibung
Voids of 1-3mm appear inside CMC products, concentrated in the center of thick walls
Ursachenanalyse
Holding is insufficient and the center of the thick wall is not compacted; entrapped gas cannot be discharged; raw material moisture vaporizes
Lösung
1)Increase holding pressure 60-80MPa for full compaction; 2)Increase mold venting; 3)Fully dry raw material
Wichtigste Erkenntnis
Internal voids are caused by insufficient holding and gas entrapment; high-pressure holding and venting are the key
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!