Injection Molding
5 görüntüleme
Flash and burrs on products
Sorun Belirtisi
Thin sheet-like excess material appears at the mold parting line, affecting assembly
Neden Analizi
Clamping force is insufficient to resist cavity pressure; injection pressure peak is too high, causing the mold to open; the mold parting line is worn or has foreign matter
Çözüm
Verify clamping force ≥ cavity projected area × (40-80MPa); reduce injection/holding peak pressure; check and repair the mold parting line
Temel Çıkarım
Flash reflects the matching problem between the clamping system and injection pressure
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!