Molds & Tooling
2 مشاهدة
ABS nozzle drool
ظاهرة المشكلة
The nozzle drips during mold opening or waiting, and cold slug marks or stringing appear at the product gate.
تحليل الأسباب
The nozzle temperature is too high, the back pressure is too large, or the nozzle orifice is worn and enlarged, so the melt flows out by itself after plasticizing; low-viscosity grades of ABS are more prone to drooling.
الحل
①Reduce the nozzle temperature by 5~10℃; ②set suck-back to relieve pressure; ③replace the worn nozzle; ④use a needle valve nozzle when necessary.
الخلاصة الأساسية
For drooling, first lower the nozzle temperature and add suck-back; if ineffective, replace the nozzle.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!