Extrusion & Post
12 مشاهدة
PVA extruded film has gel particles
ظاهرة المشكلة
PVA extruded film surface shows 0.1-0.5mm transparent gel particles
تحليل الأسباب
High molecular weight components in PVA not fully melted during extrusion form local highly crystalline regions; extrusion temperature on the low side or insufficient mixing
الحل
1) Raise extrusion temperature by 5-10°C to ensure full melting; 2) Increase screw mixing section length; 3) Inspect raw material to ensure consistent grade; 4) Replace with a finer 120 mesh screen to intercept unmelted particles
الخلاصة الأساسية
Gel particles are caused by insufficient melting; raising temperature and mixing are the key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!