Extrusion & Post
13 visualizações
PVA extruded film has gel particles
Fenómeno do problema
PVA extruded film surface shows 0.1-0.5mm transparent gel particles
Análise das causas
High molecular weight components in PVA not fully melted during extrusion form local highly crystalline regions; extrusion temperature on the low side or insufficient mixing
Solução
1) Raise extrusion temperature by 5-10°C to ensure full melting; 2) Increase screw mixing section length; 3) Inspect raw material to ensure consistent grade; 4) Replace with a finer 120 mesh screen to intercept unmelted particles
Conclusão principal
Gel particles are caused by insufficient melting; raising temperature and mixing are the key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!