Extrusion & Post
12 مشاهدة
PVA vacuum vent section material overflow
ظاهرة المشكلة
Material overflow at the PVA extrusion vacuum vent section, vent hole clogging
تحليل الأسباب
PVA melt viscosity low, overflowing at the vacuum vent section; vacuum vent section temperature on the high side, viscosity even lower, aggravating overflow; vent hole design improper
الحل
1) Lower vacuum vent section temperature by 5-10°C to increase viscosity; 2) Add a baffle above the vent hole to prevent overflow; 3) Increase screw speed to accelerate conveying and reduce residence
الخلاصة الأساسية
Overflow is caused by low melt viscosity; temperature reduction and baffle are the key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!