Injection Molding
7 مشاهدة
DSTDP surface orange peel texture
ظاهرة المشكلة
DSTDP product surface orange-peel-like uneven texture, rough hand feel
تحليل الأسباب
Mold temperature on the low side <30°C, product surface rapidly cools and solidifies, then the interior continues to shrink causing surface unevenness; injection speed too low
الحل
1) Raise mold temperature to 40-50°C to delay surface solidification; 2) appropriately increase injection speed; 3) increase holding pressure to reduce internal shrinkage
الخلاصة الأساسية
Orange peel texture is caused by rapid cooling and solidification; raising mold temperature and holding pressure are key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!