Injection Molding
1 visualizações
DSTDP surface orange peel texture
Fenómeno do problema
DSTDP product surface orange-peel-like uneven texture, rough hand feel
Análise das causas
Mold temperature on the low side <30°C, product surface rapidly cools and solidifies, then the interior continues to shrink causing surface unevenness; injection speed too low
Solução
1) Raise mold temperature to 40-50°C to delay surface solidification; 2) appropriately increase injection speed; 3) increase holding pressure to reduce internal shrinkage
Conclusão principal
Orange peel texture is caused by rapid cooling and solidification; raising mold temperature and holding pressure are key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!