Injection Molding
13 مشاهدة
Flash at the Parting Line of PBT
ظاهرة المشكلة
Flash and burrs appear at the parting line of PBT products.
تحليل الأسباب
The melt viscosity of PBT is relatively low and the fluidity is good, so it easily overflows from the parting line; the clamping force is insufficient; the injection pressure is too high.
الحل
Increase the clamping force; repair the flatness of the parting line; appropriately reduce the injection pressure; use a precision parting line design.
الخلاصة الأساسية
PBT has good fluidity and is prone to flash, which needs attention.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!