Blow Molding 11 Aufrufe

HDPE '2079851475616104457 excessive flash

Problembeschreibung

The flash at the bottle mouth and bottom mold line is thick and difficult to trim.

Ursachenanalyse

Excessive extrusion pressure/back pressure, improper pre-blowing pressure, poor mold parting line fit.

Lösung

①Reduce extrusion pressure/back pressure; ②adjust the pre-blowing pressure; ③overhaul the mold parting line fit; ④check the clamping force.

Wichtigste Erkenntnis

For large flash, reduce pressure first, then check mold fit.

HDPE; '2079851475616104457; flash; mold line; pre-blowing

War das hilfreich?

0 Personen fanden dies hilfreich