Molds & Tooling
3 Aufrufe
HDPE Shrinkage Out of Tolerance
Problembeschreibung
HDPE product dimensions are smaller than expected and cannot be assembled
Ursachenanalyse
HDPE shrinkage is 1.5-4% with obvious directionality, and mold shrinkage value selection is improper; during on-site troubleshooting, verify item by item according to this mechanism to avoid blindly adjusting the machine based solely on experience
Lösung
Measure actual shrinkage to correct the mold; lock the process; SPC for critical dimensions; after adjustment, continuously sample to verify the effect, and resume mass production only after confirming stability; change only one variable at a time and record parameter changes to facilitate locating effective measures
Wichtigste Erkenntnis
HDPE dimensional management is based on measured shrinkage; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a reference for troubleshooting similar problems in the future
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!