Extrusion & Post
14 visualizaciones
EMA Extruded Pipe Ovality Out of Standard
Fenómeno del problema
EMA extruded pipe ovality >1.05, exceeding the 1.02 standard requirement
Análisis de la causa
Pipe cooling uneven, single-side cooling; sizing sleeve design unreasonable; haul-off clamping force uneven, causing the pipe to deform under pressure
Solución
1) Adopt annular spray cooling to ensure uniform temperature reduction; 2) Optimize the sizing sleeve inner diameter and taper design; 3) Multi-caterpillar uniform clamping haul-off; 4) Increase the vacuum sizing section length to ensure full sizing
Conclusión clave
Ovality is caused by uneven cooling and clamping; annular cooling and uniform haul-off are key
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!