Molds & Tooling
5 views
ABS ejector white and ejector crack
Problem Phenomenon
[Problem Phenomenon] ABS whitening and push-through at ejector pins
Cause Analysis
Insufficient cooling and low strength, few and small ejector pins, fast ejection; during on-site troubleshooting, verify item by item according to this mechanism, avoid blindly adjusting the machine based only on experience; this mechanism has been repeatedly verified by industry materials and should be confirmed first during troubleshooting
Solution
Extend cooling; add ejector pins; reduce ejection speed; after adjustment, continuously sample to verify the effect, resume mass production only after confirming stability; change only one variable each time and record parameter changes to facilitate locating effective measures
Key Takeaway
For ABS ejector white check cooling and ejection balance; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a troubleshooting reference for similar problems later
Was this helpful?
0 people found this helpful
Thank you for your feedback!