Molds & Tooling
2 views
PU angle deviation
Problem Phenomenon
PU product angle deviation >1°, exceeding ±0.5° tolerance
Cause Analysis
Uneven shrinkage causing angle change; mold angle design did not consider PU shrinkage compensation; product deformation during demolding
Solution
1) Mold angle pre-compensation for PU shrinkage; 2) Extend cooling time to ensure setting before demolding; 3) Uniform cooling to reduce shrinkage difference
Key Takeaway
Angle deviation is caused by shrinkage and insufficient design compensation; pre-compensation is key
Was this helpful?
0 people found this helpful
Thank you for your feedback!