Molding Process
5 views
POE hardness too low
Problem Phenomenon
POE product Shore hardness 5-10 degrees lower than target, soft hand feel
Cause Analysis
POE soft nature, hardness low; too much plasticizer or softener added; crystallinity low
Solution
1) Add rigid filler 5-10wt% to increase hardness; 2) Reduce plasticizer dosage; 3) Increase cooling rate to increase crystallinity
Key Takeaway
Low hardness is caused by soft material and excessive plasticization; adding filler is key
Was this helpful?
0 people found this helpful
Thank you for your feedback!