Molds & Tooling
7 visualizações
PPS Mold Sticking and Difficult Demolding
Fenómeno do problema
Products stick to the cavity and are scratched during demolding.
Análise das causas
High mold temperature causes thermal bonding between PPS and the mold; insufficient draft angle or improper surface condition.; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based only on experience
Solução
①Optimize mold temperature and cooling; ②increase draft angle; ③select appropriate mold surface treatment; ④balance the ejection system.; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
Conclusão principal
PPS mold sticking is related to high mold temperature; demolding design must adapt to the high-temperature process.; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!