Molds & Tooling
5 görüntüleme
PPS Mold Sticking and Difficult Demolding
Sorun Belirtisi
Products stick to the cavity and are scratched during demolding.
Neden Analizi
High mold temperature causes thermal bonding between PPS and the mold; insufficient draft angle or improper surface condition.; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based only on experience
Çözüm
①Optimize mold temperature and cooling; ②increase draft angle; ③select appropriate mold surface treatment; ④balance the ejection system.; after adjustment, take continuous samples to verify the effect, and resume mass production only after confirming stability
Temel Çıkarım
PPS mold sticking is related to high mold temperature; demolding design must adapt to the high-temperature process.; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!