Extrusion & Post
13 visualizações
DSTDP extruded film longitudinal streaks
Fenómeno do problema
DSTDP extruded film surface has continuous streaks 1-3mm wide along the extrusion direction
Análise das causas
Die lip locally damaged or gap uneven; unstable flow produced in the melt residence zone inside the die; pressure fluctuation at the screw front end
Solução
1) Check die lip flatness and gap uniformity ±0.01mm; 2) clean die interior to remove carbonized matter in residence zones; 3) install gear pump on extruder to stabilize melt pressure; 4) polish die lip to Ra<0.1μm
Conclusão principal
Longitudinal streaks are caused by die defects and pressure fluctuation; die maintenance and pressure stability are key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!