Extrusion & Post
14 visualizaciones
DSTDP extruded film longitudinal streaks
Fenómeno del problema
DSTDP extruded film surface has continuous streaks 1-3mm wide along the extrusion direction
Análisis de la causa
Die lip locally damaged or gap uneven; unstable flow produced in the melt residence zone inside the die; pressure fluctuation at the screw front end
Solución
1) Check die lip flatness and gap uniformity ±0.01mm; 2) clean die interior to remove carbonized matter in residence zones; 3) install gear pump on extruder to stabilize melt pressure; 4) polish die lip to Ra<0.1μm
Conclusión clave
Longitudinal streaks are caused by die defects and pressure fluctuation; die maintenance and pressure stability are key
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!